Cube Long Arrow Right External Link angle-right Search Times Spinner angle-left

Star Lite Mk II - Complete Disassembly Guide

  1. Place the Star Lite Mk II on a soft, protected surface to avoid any possible scratching of the anodized finish. Then proceed with removing the 10 outer short Philips screws from the backplate.
undefined

2. Once the backplate is carefully removed, you are presented with the components underneath. Start off by removing the battery.

undefined

undefined

3. Remove the 4 Philips screws that hold the battery in place.

undefined

4. I/O board Removal: Lift the ribbon cable clamp to detach the ribbon cable. Then, remove the 2 Phillips screws that hold the IO Board in place. You can then lift out the I/O Board.

undefined

5. Disconnect the Display connector, Wireless and Bluetooth Antennas.

undefined

undefined

6. Disconnect the SSD from the mainboard.

undefined

7. Disconnect the following ribbon cables/connectors from the mainboard: I/O Board, Keyboard, Touchpad and Backlight.

undefined

8. Removal of the mainboard: Remove the 4 Philips screws around the edge of the mainboard.

undefined

undefined

undefined

undefined

9. Lift the mainboard out carefully and then disconnect the speaker.

undefined

10. Remove the 2 Philips screws from the speaker.

undefined

11. Remove the 4 screws in each hinge.

undefined

undefined

12. Lift the hinges up straight about 90' degrees which will leave enough space for the chassis to be separated from the display array.

undefined

undefined

13. Disassembly is now complete.

undefined

14. Reassembly is the reverse of these steps.